Home / Forum / Assembly / Unlocked Z Nut Lock / Reply To: Unlocked Z Nut Lock

Profile photo of JeffJeff
Post count: 157
#10260 |

I took it apart, and sure enough, I have the wrong sized nut lock on there. I’m printing one of the 11mm parts (And I went with 100% infill, why not)?

It is going to be a pain to keep those nuts tight on the back, since it’s so hard to get a driver back there once the pipes are installed. You might be right, Dave, this might end up needing a lot of dis-assembly 🙂 At least I didn’t have to get the Z Axis pieces away from the Z motor holder, that was really difficult piece to get in there. Also the Z shaft coupler…