Home / Forum / Hardware / VAC Shoe remix / Reply To: VAC Shoe remix

Profile photo of JamesJames
Post count: 25
#10567 |

I’ve got a new design figured out, just having a little trouble executing. My 3D modeling game isn’t quite on point, but I’m getting there.

If you’ve ever seen how the access cap on a waste water tank for an RV spin clamps on, that’s the route I’m going. I trimmed 9mm off the top of the vac shoe, and working on putting some hooks on it that will spin clamp on to the tabs that come out the side of the lower clamp for the DW660. If that makes any sense…

I like this shoe for doing deeper cuts. The larger shoe, to me, is more for engraving and shallower cuts.

  • This reply was modified 6 months, 1 week ago by Profile photo of James James.