Home / Forum / Updates / MPCNC Version 2 -opinions- / Reply To: MPCNC Version 2 -opinions-

Profile photo of vicious1vicious1
Post count: 2627
#10886 |

I saw that and left a comment. Now that I think about it you might want to change it up a bit for the new one, not sure how different it is but the tool center should be closer and the legs of the holder can be shorter, I think. All because there is no nut trap in the way. but depending on your code you might be good to go already, ill look at it once I start the new corner (#857) printing.

This parametric stuff is hard to do in your head all at once.