Reply To: Table with Side Panels idea to cut down on dust

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Table with Side Panels idea to cut down on dust Reply To: Table with Side Panels idea to cut down on dust

#10941
Profile photo of Jeffeb3
Jeffeb3
Participant

I made holes for the leg conduit to go through the bottom. I used a 7/8″ forstner bit, which is a little large, so I made the holes just a hair off center (I specifically tried to make it off towards the two screws in the foot so the back was more supported). Afterward, they were much more rigid.