Home / Forum / Troubleshooting / My first successful print! / Reply To: My first successful print!

Profile photo of WalterWalter
Post count: 186
#10985 |

I did a little speed test. so far I’ve gone up to 90mm/s In cura on a 40mm cube. if it’s actually hitting those speeds in that short a run I don’t know. but the results were promising. I don’t expect that the layer adhesion was that great but it came out solid and had only one layer that showed a problem, and I’m pretty sure it’s from the same time I put the camera and the weight of my arms down on the platform to film.