Home / Forum / Software / Octoprint / Reply To: Octoprint

Profile photo of JeffJeff
Post count: 158
#11143 |

If you are using it as a 3D printer, then you’ll have the same experience, I’m sure.

A cnc mill isn’t quite the same, because you need to do some setup, clamping stuff, setting the 0,0,0, etc.

I still can’t leave mine to cut alone. I hold the vacuum while it’s cutting. I’m still not 100% confident something won’t fall apart either. But when I get to that stage, I’ll appreciate the time lapse video. Especially if something goes wrong, I think.

I haven’t hooked mine up to octoprint yet, because I’ve been experimenting with grbl instead.