Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

New Home Forum Software Development Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC Reply To: Image2Gcode – Free Raster Image Laser Engraving Software – Modified for MPCNC

#11287
Profile photo of keedley
keedley
Participant

Ok, here pics of interface tabs and gcode generated.

screenshots
https://yadi.sk/i/SagrQwnirHQib
https://yadi.sk/i/207nA5dRrHQih
https://yadi.sk/i/ZT1DigqlrHQis

gcode
https://yadi.sk/d/87_ysnp_rHQrN

i’m running it by using a Pronterface using a 5W diode, so half of the power is enough to burn black on 3000 feed.
Also, ‘5’ value is leaving only slightest marks on this speed.
i’m using a dedicated corexy platform for this setup and diode is driven from servo pins using my own Marlin modification. G1 is firing laser, G0 is not firing, M03 code switching laser on and sets “spindle’ power as 0..255 value, directly connected to analogWrite on servo pin where laser TTL is attached.