Reply To: Using Machinekit (Linuxcnc) on a BBB beaglebone black / Cramps board with MPCNC

New Home Forum Software Development Using Machinekit (Linuxcnc) on a BBB beaglebone black / Cramps board with MPCNC Reply To: Using Machinekit (Linuxcnc) on a BBB beaglebone black / Cramps board with MPCNC

#11586
Profile photo of vicious1
vicious1
Admin

I like the idea of controlling each stepper independently, fine adjustments.

The steppers sounded like the voltage was way up on them normally I don’t hear mine at all. Are you over volting them?