Home / Forum / Troubleshooting / MPCNC has the Jitters / Reply To: MPCNC has the Jitters

Profile photo of RAGIIRAGII
Post count: 39
#12407 |

OK. So I have tightened the belts some, polished the conduit, rotated conduit so no seams on the bearings, checked for square, and now have it attached to a table.
I have check vRef (.7, .71, and .4). I did a test run of a circle with the shown Tool from Estlcam

I am still not getting a smooth operation.

Not sure what to try next.

  • This reply was modified 5 months, 1 week ago by Profile photo of RAGII RAGII.