Home / Forum / Updates / Updated Center Parts / Reply To: Updated Center Parts

Profile photo of MichaelMichael
Post count: 14
#12564 |


I think the table is too big and the pipe is not so good.
Mine is ~45 in x ~28in and I think I’ll scale it down a little bit, not for flexing (I’m using stainless steel). It’s too big for my needs.

So guys, testing goes verry verry well. In a few hours I’ll have complete middle assembled (last part is printing now). Even without 1 TopBottom, “connected” to the pipes, this new middle is awesome. For this design you dont need to tighten the bolts. Tight them only to keep the parts together.
The long screw from middle who connects all 6 parts is ~14mm/5.51 inches long.

Nice job Ryan.