Reply To: Z-axis plunges past table at beginning of print

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Z-axis plunges past table at beginning of print Reply To: Z-axis plunges past table at beginning of print

#12595
Profile photo of vicious1
vicious1
Keymaster

What stepper drivers are you using and what amperage do you have them set at? The zaxis should be roughly half of the X and Y axis.

As for going past the bed you need to reset the zero before you start a job and make sure your axis is moving in the right direction.