Home / Forum / Troubleshooting / HELP Can't make square cuts / Reply To: HELP Can't make square cuts

Profile photo of Jason ChristmanJason Christman
Post count: 35
#12683 |

That 3mm difference is the same measurement I was getting when everything was assembled, so it doesn’t seem to make much difference with the rigid-z parts or the rails in place. But I don’t know if this is specifically an issue with the middle joiners, or something off on all my middle parts.

I have my calibration cubes coming in closer, I dropped the temp 5 degrees, and now have 19.9×20.3×20.3 cubes, which I’m not sure how to deal with.