Home / Forum / Troubleshooting / Ramps/Mega movement issues / Reply To: Ramps/Mega movement issues

Profile photo of JasonJason
Post count: 322
#12887 |

All min and max endstops show open for x y and z

was getting a checksum error as well but i think that is because I dont have an sd card reader

would the mintemp error cause this?

1 pin is loose. The single pin just above all the end stop pins. Its label 12c on my ramps what does that one do?

  • This reply was modified 5 months ago by Profile photo of Jason Jason.