Home / Forum / Troubleshooting / HELP Can't make square cuts / Reply To: HELP Can't make square cuts

Profile photo of Jason ChristmanJason Christman
Post count: 35
#13180 |

I went ahead and printed the new middle assembly. I have it all together and adjusted to what seems pretty square. I’ll hopefully get a chance to test it later this week.

The only problem with the new design I’ve run into is that the pineapple coupler seems way too large for the 5/16 threaded rod. I even shrank it down 98.5% and reprinted, but it still wouldn’t tightly hold the rod. I think I can shrink it further, but thought it was odd; anyone else seen this?