Reply To: Heat a bolt if the tube is too tight

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Heat a bolt if the tube is too tight Reply To: Heat a bolt if the tube is too tight

#13794
Profile photo of Mark
Mark
Participant

Here are the feet and corners. Again, the PLA is not happy, look at the deflection of the slot and I cannot get the steel in to full depth. (Obviously)

The corner brackets you can get away with as they are a snug fit, but the bolt holes all line up. (Used the short lengths of steel just to mock up for the photo.)

I did not think that 0.4mm would make so much difference