Reply To: Increasing feed rate between cuts in Estlcam (or Repetier)

New Home Forum Software Development Increasing feed rate between cuts in Estlcam (or Repetier) Reply To: Increasing feed rate between cuts in Estlcam (or Repetier)

#14093
Profile photo of Didier
Didier
Participant

Hi, I don’t think so, i think it could be a good option to add to Estlcam. At the beginning I edited my gcode to do that but it is not a good solution, i wasted time so now i prefer launch the job on my vicious and wait 🙂