Home / Forum / Troubleshooting / Cut Depth / Reply To: Cut Depth

Profile photo of BryanBryan
Post count: 10
#14113 |

Yes it was its actually showing up in the Gcode as well I am having it lift off the bed 1 inch while moving (I know that it is ridiculously high) then I tell it to go down .25 inches over 4 cuts but at the end it is stopping at .036. I do start with the LCD showing me 0 on all axis (X,Y,Z). It does appear that it is lifting the 1 inch and the X,Y dimensions are almost spot on.