Home / Forum / Troubleshooting / Can't get it to start where I want / Reply To: Can't get it to start where I want

Profile photo of Matt saegerMatt saeger
Post count: 111
#14343 |

Changed my X,Y,Z steps to the values from the prusa calculator and now it is plotting the right size and I can figure out where it’s going to put the thing on the paper yay! Maybe one of you guys could tell me if I should do anything with the acceleration and feed rates? I have not had to mess with those in my 3D printing experience. I think I may need to change something one the Z it’s making funny noises now it didn’t with the wrong steps/mm.

Now I need to get this thing in the garage and get it all leveled and stuff.