Home / Forum / Troubleshooting / Can't get it to start where I want / Reply To: Can't get it to start where I want

Profile photo of Matt saegerMatt saeger
Post count: 111
#14355 |

I changed the configuration.h

I have 100,100,2267.72,100 for steps I left the acceleration and feed at what you had. I just used the numbers from the prusa calculator and it makes sense since they are half of what was in there for 1/32 micro stepping.

The Z still ran fine it just sounds different but maybe I need to adjust the driver current or something is rubbing. X AND Y are better. With the wrong steps in there if I told it to move 50mm in one shot the motors would lock and now they run good.

My 200×200 square was perfect size and even square.