Home / Forum / Hardware / table not quite level / laser attachment / Reply To: table not quite level / laser attachment

Profile photo of Mike CunninghamMike Cunningham
Post count: 12
#14466 |

Short answer: No.

Longer Answer: No, it will not.

Assuming that you have a decent powered laser, that will be focused at 30-60mm, you should have a usable range of about 15mm (7.5 up and down from the point of focus)

If you are doing image burning, the picture will get a little lighter/darker (depending on your focus point) towards one end of the table; but 2mm shouldn’t be noticeable.

On the other hand, you could always loosen the flex foot on that side, lift the conduit 2mm, and re-tighten it… personally, I used a 1/2″ 6″ ratchet extension, with a socket in it, to even mine up.