Home / Forum / Builds and Things Built / 5W+ Laser / Reply To: 5W+ Laser

Profile photo of Leo69Leo69
Post count: 336
#14650 |

Marlin firmware uses the analogWrite function to drive the fan output , which uses 8-bit PWM at 490Hz frequency. Firmware mods are possible that can increase the frequency and/or the resolution by reconfiguring one of the 16 bit timers and writing to the OCR register directly instead of through the analogWrite function. The increase in PWM frequency doesn’t really make a difference with laser engraving from what I’ve seen but the increase in PWM resolution does help with high powered lasers.