Home / Forum / Builds and Things Built / My 5' x 5' build / Reply To: My 5' x 5' build

Profile photo of JasonJason
Post count: 322
#15083 |

Well I think I got it sorted…

Rewired my steppers to series.
Re ran my belt and loosed off all the bolts on the rollers so they could be spun by hand but the nuts are still locked.
Figured out the flashing issues I was having. Reduced the travel speed to 175 made it move much better. Got my proper dimensions entered in as well.
1200 x 1200 movable size.. Actual cut probably 1100mm square.

Just need to finish redoing my cable management, and build a speed controller. Then once the rest of my laser parts arrive get that bad boy running.

Also want to figure out how to set it up to turn off and on thru firmware and probably a SSR. Anyone have any solutions?