Home / Forum / Troubleshooting / 525 XY Tension (Some Bearings Not Touching) / Reply To: 525 XY Tension (Some Bearings Not Touching)

Profile photo of ToddTodd
Post count: 13
#15250 |

Yes, without belts. I’ve tried several different gcodes that move the steppers from full width/height diagonally. I haven’t tried them isolated just X and Y.

This might be a dumb, question but I have the vref set to 0.98 for X/Y. My motors are 1.4a, but now I’m wondering if I calculated that incorrectly. Are these really 11v?