Home / Forum / Builds and Things Built / MPCNC…My series of unfortunate events! / Reply To: MPCNC…My series of unfortunate events!

Profile photo of BasharBashar
Post count: 9
#16329 |

I upped the voltage on the extruder motor to 0.6V, and I think it definitely made a difference. But the printed key chains you see in the pictures have missing infill near the hole where the ring goes, as if its some sort of under extrusion. There is slight misalignment between the layers, and over extrusion near corners.

  • This reply was modified 2 months, 1 week ago by Profile photo of Bashar Bashar.