Reply To: I'm New! – Z axis and extruder working but x/y won't move

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC I'm New! – Z axis and extruder working but x/y won't move Reply To: I'm New! – Z axis and extruder working but x/y won't move

#16408
Profile photo of Troy Proffitt
Troy Proffitt
Participant

In ponterface, i am currently set at 200 mm. I didn’t get the board from you. I’ll probably order a new one just in case. I did eyeball the underside of the ramps board and it did have a few small splashes of solder that I took off. I’ll double check the solder joints under those jumpers…. I have tried to move the z driver to x and it didn’t change, and the driver that was on x worked fine on z.