Reply To: Different problems on the three axes (including the Z buzz / dive)

New Home Forum don’t use this one, I need to sort and delete -Troubleshooting Different problems on the three axes (including the Z buzz / dive) Reply To: Different problems on the three axes (including the Z buzz / dive)

#16614
Profile photo of bradhaas
bradhaas
Participant

@vicious1 thanks, I’ll try that. Is it possible there’s a stepper problem when one motor works and the other doesn’t, and they’re both connected to the same stepper? I will try switching things up though, to see if I can get that loose motor to lock when connected to one of the other ones.

Looking at your gcode, it dawns on me that I may have used the wrong file, that I created before enabling the “add F to every instruction” thing in Estlcam. I’ll double check that.

@Scott I’m pretty sure everything you asked about is good, but I’ll double-check. I did verify the vref for the Z driver but I haven’t tried increasing it yet.