Reply To: Different problems on the three axes (including the Z buzz / dive)

New Home Forum don’t use this one, I need to sort and delete -Troubleshooting Different problems on the three axes (including the Z buzz / dive) Reply To: Different problems on the three axes (including the Z buzz / dive)

#16615
Profile photo of bradhaas
bradhaas
Participant

ARGH! I re-saved the gcode from Estlcam with “repeat F commands” enabled, and a few of the Z commands are set correctly to 180, but the rest are set to 900! Anyone know offhand where I can fix that in Estlcam?

I changed around my motors/steppers and it remains the same – one motor is locked and the other still has some play. I discovered that the same is true on the Y rollers but much less so. In both cases, it’s the one that’s more distant from the driver, if that makes any difference. I did check that the wire connection between the X motors is secure.