Reply To: Electrical engineering – wires and ohm

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Electrical engineering – wires and ohm Reply To: Electrical engineering – wires and ohm

#16644
Profile photo of vicious1
vicious1
Keymaster

Yes you either need the resistor, a thermistor, or change the firmware. the resistor is easiest if you plan on using the machine for more than cnc routing.

Ramps Stack

Steppers can be parallel or series, http://www.vicious1.com/wiring-the-steppers/