Home / Forum / Builds and Things Built / MPCNC 2.8w $100 laser add-on complete / Reply To: MPCNC 2.8w $100 laser add-on complete

Profile photo of KalleKalle
Post count: 4
#16667 |

Hi ManuCNC
What tpye of laser did you bought?
Normally your laser should have three wires: plus – ground – ttl-input
Connect plus and ground to your power supply.
And connect ground and ttl to your ramps/arduino.
The ground connection is the same in both cases.
This should work.

Greetings Kalle