Reply To: Machine wanders off in middle of routing, then gets back on track sometimes?

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Machine wanders off in middle of routing, then gets back on track sometimes? Reply To: Machine wanders off in middle of routing, then gets back on track sometimes?

#16890
Profile photo of Ryan
Ryan
Keymaster

Your router is very large, and your z moves are more than 2x’s the firmware max. Try plunge rates of like 5mm/s not 20.

Your belts are at a pretty extreme angle, you are bound to get errors from this as well.