Reply To: One part too big for my printer

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC One part too big for my printer Reply To: One part too big for my printer

#16990
Profile photo of Jo Lallo
Jo Lallo
Participant

Cool. It’ll be two or three days before I finally start my experimentation on that part, but I’ll run it by you when I do. Thanks for the quick reply, by the way.

Another thought I had, now that I’m about 90 print-hours past the point of no return. I picked the design intended for the smallest conduit diameter, with the expectation that every little bit of size reduction would increase my chances of actually getting the parts printed out of my dinky machine. Assuming I succeed in completing it, would you say the 1-inch model is a superior choice if I decide to upgrade in the future? It seems like it simplifies the purchase of pipe, at the very least.