Home / Forum / Builds and Things Built / Abs build / Reply To: Abs build

Profile photo of johanjohan
Post count: 32
#17070 |

The extruder motor does get a little warm but nothing extreme.
The malyan drivers haven’t got pots to set it and it is set very conservative.

My last roller I am still printing is probably failed, I can see a crack on the webcam image.
Can’t open the door because on higher prints the abs is most certainly going to crack and warp.
Hoping it’s only a small one and its still fixable with some acetone.

Been researching how to set the driver voltage, shouldn’t be to big of a problem I guess.
Also trying to figure out what software to use for milling, have used aspire and mach3 before but if I’m correct I can’t use mach3 with ramps.