Home / Forum / Hardware / Laser Tutorial Question / Reply To: Laser Tutorial Question

Profile photo of JasonJason
Post count: 321
#17268 |

Shoot ok. I thought the voltage divider was a safe option.

So to clarify the procedure I should follow is
1. Flash to pin 42
2. Test for variable voltage ~5v at 100% fan at pin 42.
3. Connect 12v to driver (possibly where i made a mistake.. I connected ttl at the same time)
4. Turn on Current LED then adjust voltage to 5.5v turn off current led.
5. Attach load to laser + -, connect 12v and ttl.
6. adjust voltage to 1.7