Home / Forum / Troubleshooting / Extruder Heater Problem / Reply To: Extruder Heater Problem

Profile photo of CesarCesar
Post count: 14
#17454 |

Hi Guys I have tested the resistance of both the heater element and the thermistor reading 84 ohms and 4.4 Ohms respectively
is there a way to bypass the safety features on the extruder just to test if the temperature wire is working. while reading the Arduino code I noticed that if the thermistor does not register at least 5 degrees the extruder would not work to prevent a wiring problem cause a fire.