Reply To: Parallel vs series on your steppers

New Home Forum Updates Parallel vs series on your steppers Reply To: Parallel vs series on your steppers

#17658
Profile photo of Markus Hauser
Markus Hauser
Participant

Now set up mine in series, did not change microsteps, still 1/32, lowered voltage to .7v (even my steppers are rated to 2A), could not run my mpcnc too fast cause i switched to Estlcam / Arduino uno and it can not handle 195mm/s, but who cares, i got plenty of time. But i am thinking of going down to 1/16 for Z axis to lower the overall stepload for the small Uno… Dunno if this is really required, will test if it makes any difference.