Home / Forum / Troubleshooting / Planning for Calibration / Reply To: Planning for Calibration

Profile photo of Jo LalloJo Lallo
Post count: 18
#17799 |

Okay, I’ve got it bolted down. Here’s a test print that’s almost entirely curves and thus a worst case scenario for wobbles (I would imagine). Is there any reasonable way to determine where the wobbles are introduced? Rollers too tight, vertical stability problems, not enough belt tension, etc? Also, with a machine of my dimensions (~ 24x14x6 now that it’s screwed down), what’s a reasonable maximum stability?

Also, though I’m pretty sure I tuned it out, initially I was seeing diagonal measurements about an eighth of an inch off. Would that manifest as merely “parallelograms” or are there other symptoms.

I suppose I should ask (or should have earlier) is there a “calibration master post” or something?