Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Development Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#17974
Profile photo of Juergen Schilling
Juergen Schilling
Participant

Sorry, seems I’m having a long line this Monday morning… 😉 Haven’t seen that there are GRBL compatible pin assignments for selection… Thanks for clarifying… It might be good to add a comment in Estlcam, that those are compatible with CNC shields…

I’m having the CNC shield V3, which I guess doesn’t support the PMW for the spindle and pin 11 is assigned to the Z limit switch… But I’ll check…

Thank you very much, I’ll give it a try…

Cheers,
Juergen