Home / Forum / Hardware / Laser Tutorial Question / Reply To: Laser Tutorial Question

Profile photo of JasonJason
Post count: 328
#18065 |

Is there a code to get the reading of T0? It seems like this new mega is not reading the resistor. I checked the resistor with my meter and it is fine.

Going to run a M119 tonight to see if the end stops are reporting properly. Even though it still does not move with the end stops unplugged.

It would be my luck though if this Mega board was defective upon delivery, and of course the guy is not responding on ebay. Claim time I guess.

  • This reply was modified 1 month ago by Profile photo of Jason Jason.