Reply To: Aluminium…HELP PLEASE

New Home Forum Troubleshooting Aluminium…HELP PLEASE Reply To: Aluminium…HELP PLEASE

#18392
Profile photo of vicious1
vicious1
Keymaster

Is your machine planer to your work surface?

Check all 4 corners to make sure they are the same height, as close as you can get them, you can tell even .3mm will make a difference. The other way is to just cut further through the material, that is the more common way to compensate, because nothing is perfect. You can also mill your entire work surface flat but then when you raise your material up you can easily get it out of whack again so just cut further through your material.