Reply To: MPCNC Printer Setup Problem

New Home Forum Getting Started MPCNC Printer Setup Problem Reply To: MPCNC Printer Setup Problem

#18396
Profile photo of san-chy
san-chy
Participant

Okay, I’m going to update my firmware.

My center assembly is the very first version you published, so I don’t have the better middle Z. My old printer was too small to print it.
The printer runs fine without all the bearings touching. Only if you are printing very small details there are some errors.
I’m going to print the better middle Z this week, I suspect after that the problem will solved itself, hopefully ^^