Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#18588

Guys, sorry haven’t found a separate ESTLCAM thread, so will ask my noob question here:
1. How can I change the speed of engraving/cutting in ESTLCAM? (or is this a task for control software, in my case Repetier? I found the general “Speed” control in Repetier-host, and I am lowering it to get the lower speeds of cutting, but I feel like it is not the rightest method 🙂 )
2. How to change Z cutting step. Searched everywhere, but can not find how to change the layer thickness from default 1mm to 0.5mm

My problems come from using very weak spindle ( I’ve got Proxxon 100W at the moment ), and I would like to make cutting less aggressive comparing to default 🙂