Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#18591
Profile photo of Matt
Matt
Participant

Sergey:

1. In ESTLCAM, in the upper right corner are the “Tools”. Think of these as just a list of “saved settings”. Besides the width of the end mill you’re using, hover your mouse over the other columns and find one for X/Y feedrate. That is the cutting speed for horizontal movements. There is also a Z feedrate which is the cutting speed for Z moves (plunging or drilling).
2. In the same are as 1 (above), there is a column for Z steps (it has a little picture of steps). That is where you can changes the Z cutting step.

You can also change the name of the pre-defined defaults to make sense to the end mills you are using or add your own.

Attachments: