Reply To: Milled/printed Prusa Style Printer

New Home Forum Builds and Things Built Milled/printed Prusa Style Printer Reply To: Milled/printed Prusa Style Printer

#18642
Profile photo of Jasoroony
Jasoroony
Participant

Mine came disassembled, and yes, I assembled it so the throat was very close to the gear. I also used a dremel with a small burr bit to round the inner edges of the throat’s filament hole since the lever filament hole wasn’t quite in the right place (cheap extruder) so it gets loaded at a slight angle. I could see the filament being scrapped (and flaking) before doing that. Now it’s actually quite good.