Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#18752
Profile photo of Curt
Curt
Participant

To make sure I am setting things up correct, how should the jumpers be installed? I thought the default jumper settings from Ryan were 1/32. Christian states in his program to “set drivers to 1600 steps/rev for best performance”. What should the jumper settings be for this?