Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#18796
Profile photo of Marvin
Marvin
Participant

Tested All End stops Working.

Having difficulty setting up touch plate I assume by the Instructions I will have-to unplug my LCD Screen as it looks like it uses Aux 4 already 🙁 will stink to have to take box apart to reconfigure as 3d Printer. I have tried sending 5v to top pin of aux 4.

also does anyone know what the (*1) under limit switch Z is supposed to mean.

Also I made a STL for the Touch Plate just made one today if anyone needs its I will put link Below

http://www.thingiverse.com/thing:1799974