Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#18860
Profile photo of Markus Hauser
Markus Hauser
Participant

1st. Uno with CNC Shield or RAMPS?
2nd. select proper board ins estlcam, on the right side there is a display of the used pins
For RAMPS the sensor pin ist on AUX 4 second pin of the row D17, ground is the second lowerst pin
one goes to the toolbit (ground) (use alligator clip), other (input) goes to touchplate
If you want a cool cheap touchplate check http://www.thingiverse.com/thing:1799974
drill a 2mm hole at the right up corner, glue aluminium foil to top and the sides (one piece!!!) and fix the lead to the screw so it makes contact to the foil

For CNC-Shield check inside Estlcam, should be A5
3rd. enable pins in estlcam
4th. under machine controll you can do surface scanning, zeroing…