Reply To: Brittle Hatchbox PLA prints

New Home Forum Getting Started Brittle Hatchbox PLA prints Reply To: Brittle Hatchbox PLA prints

#18869
Profile photo of Geoff Brown
Geoff Brown
Participant

Yeah, I did the 100mm test (it is how I calibrated my e-steps). I actually dropped the speed down to 35 for printing the XY and it looks even better still. At a print speed of 40, when printing the XYZ, I can see one spot in the exact same area of both prints where there was layer separation (pic attached).They both still feel really strong and I cannot get that area to creak (even tried jamming something into the crack to get it to separate and it wouldn’t) by force and twisting. I was thinking of just using them anyways, can always reprint them if I run into issues.

Attachments: