Reply To: Perfect built at last (after a lot of tuning) – oval circles and rectangulars

New Home Forum Troubleshooting Perfect built at last (after a lot of tuning) – oval circles and rectangulars Reply To: Perfect built at last (after a lot of tuning) – oval circles and rectangulars

#19132
Profile photo of PureField
PureField
Participant

I am using Inkscape to create the pattern with the GCODE extension to export path to gcode. I then import the gcode into Repetier Host and convert it using the Save for SD Print option to put it on an SD-card to read on the LCD. How can I tell the speed?

%
(Header)
(Generated by gcodetools from Inkscape.)
(Using default header. To add your own header create file “header” in the output dir.)
M3
(Header end.)
G21 (All units in mm)

(Start cutting path id: path4404)
(Change tool to Default tool)

G00 Z5.000000
G00 X190.616031 Y77.612219

G01 Z-0.125000 F100.0(Penetrate)
G03 X191.322088 Y78.182530 Z-0.125000 I-5.398729 J7.405952 F400.000000
G03 X191.711573 Y78.590627 Z-0.125000 I-2.358425 J2.640772
G03 X192.219280 Y79.246967 Z-0.125000 I-9.640186 J7.981640
G03 X192.462603 Y79.631045 Z-0.125000 I-3.046680 J2.199259
G02 X192.591853 Y79.776179 Z-0.125000 I0.472870 J-0.290998
G02 X192.689981 Y79.810191 Z-0.125000 I0.098128 J-0.124547
G02 X192.807944 Y79.762793 Z-0.125000 I0.000000 J-0.170491
G02 X192.855343 Y79.651718 Z-0.125000 I-0.106447 J-0.111075
G02 X192.819688 Y79.475603 Z-0.125000 I-0.452772 J0.000000