Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#19312
Profile photo of Juergen Schilling
Juergen Schilling
Participant

Hi Mike,

yes, the settings for 1/8 micro steps with 1600 steps per unit and 200 steps per turn steppers is the right one. I’m using this setting and it works perfect for x/y-axis… For the z-axis I’m using 1/4 and 800 steps per unit…

By the way, I’ve had now a few tries without sensing input on my machine and don’t had any issues right now. I’m currently start to build a tool length sensor and a touch plate and will wire it to the Ramps 1.4 board. First tests work well, but I’ll give it some further tries…

@Christian: Thank you very much for this nice work…

Cheers,
Juergen