Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

New Home Forum Software Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support Reply To: Estlcam with experimental Arduino Mega2560 / Ramps 1.4 support

#19370
Profile photo of Juergen Schilling
Juergen Schilling
Participant

One thing I have in mind, if you don’t want to calculate the right reverence voltage, just set the trimmer to the direction with the lowest reference voltage. Then start moving the motor and turn the trimmer into the other direction until the motor starts moving. After this, turn it just a little bit more and you have the correct current setting for your motor to move properly…

Cheers,
Juergen